VHT Flameproof Heat Resistant Paint in Can - Matt Black

VHT Flameproof Heat Resistant Paint in Can

VHT Flameproof Paint with ceramic is formulated for high temperature paint applications. The exclusive ceramic formula increases heat dispersion to maintain & protect paint finish. Ideal for all high temperature applications. Withstands intermittent temperatures up to 2000°F (1093°C). Oil and gas resistant. Ideal for: exhaust components, radiator & cooling system components & manifolds. CAUTION: for maximum product performance read entire label and directions prior to spray application.

Heat resistant matt black paint

This matte black paint is heat resistant up to 1093 degrees Celsius and equal to color RAL9005. Thanks to the special ceramic formula, the color remains deep black for a long time, without discolouring or fading.

How do I use VHT heat resistant paint?

Step 1: Prep the surface

Prepare surface by removing all loose paint, dirt, rust, grease, wax, etc. For best results use a quality grease and wax remover to clean the surface. Scuff the surface by using a scuff pad, wire brush or equivalent. Wipe down the surface again with a grease and wax remover, then let dry.

Step 2: Masking off

If needed, mask-off surrounding areas not intended for application. Use at temperatures between 60°F (16°C) and 95°F (35°C) and when humidity is less than 60%.

Step 3: Application

Thoroughly shake and stir contents to a uniform consistency. It has been formulated to be applied by HVLP spray gun. No reduction needed. Note: All spray guns may apply differently. Always spray a separate test panel first and follow spray gun directions carefully. Holding the gun 6-8'' from the substrate, overlap each stroke by 50% to maintain a wet edge. Apply all coats within 1 hour, allowing 10 minutes between each coat. For additional coats after 1 hour, wait 7 days for paint to cure. Dries to the touch in 1 hour. Can be handled in 3 hours.

Step 4: Curing

After paint is completely dry it must be cured to substantially increase the durability of the finish and enhance chemical resistance. Finish is not chemical resistant until cured.

Off the vehicle

Bake at 250°F (121°C) for 30 minutes then let cool for 30 minutes. Bake at 400°F (204°C) for 30 minutes then let cool for 30 mintues. CAUTION: Do not exceed the heat tolerance of the least heat tolerant part.

On the vehicle

Run at idle for 10 minutes then cool for 20 minutes. Run at idle for 20 minutes then let cool for 20 minutes. Run under normal operating conditions for 30 minutes then let cool.

Step 5: Clean-Up

After application, clean tools with Acetone/Xylene.