Rust-Oleum EPOXYSHIELD Garage Floor Coating - Grey

Rust-Oleum EPOXYSHIELD 2K Garage Vloercoating Set

Rust-Oleum EPOXYSHIELD Garage Floor Coating is a user friendly and easy to apply water-based epoxy garage floor coating with an ultimate adhesion and durability. The product has an excellent wear, impact and abrasion resistance like heavy foot and vehicle traffic. Resists chemicals and standing water.

Recommended use

Apply on concrete floors, which are completely clean and dry. It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent a good adhesion. Epoxyshield can also be applied on old good adhering coatings.

Thanks to the free instructional DVD and manual, applying this Epoxy Floor Coating is a piece of cake!

What does Rust-Oleum EPOXYSHIELD Garage Floor Coating Set Contain?

• Rust-Oleum EPOXYSHIELD 2K Epoxy Floor Coating
• Degreaser for concrete
• Decorative chips
• Anti-Slip grains
• Stirrer for mixing the 2K paint
• Instructional DVD

How do I apply 2K Epoxy Floor Coating?

1. Do not mix Paint Chips with Epoxyshield. Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating onto the surface. Do not leave container in direct sunlight. Mix again before applying. The product must be used within 1 to 2 hours of initial mixing (pot life, see table). This time decreases at higher temperatures.
2. Apply when air (ambient) temperature is 15-35ºC and relative humidity is below 80%.Concrete floors take a long time to warm up; make sure the previous day has also been at least 15ºC prior to painting. Minimum floor temperature for painting is 13ºC. Painting in midafternoon ensures the best cure.
3. After the full 60 minutes use a paint roller (20 cm) to apply an even coat of Epoxyshield onto the surface. Apply in sections of 1,5 x 1,5 m so that paint chips can easily be scattered on the freshly coated surface. Maintain a wet edge to prevent lap marks and gloss differences. Sprinkle the decorative paint chips onto the wet film (note: this step maybe skipped if chips are not desired. This will not affect the performance of the coating). Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). Only one coat is necessary. This product must be used within 3 hours of initial mixing (pot life).
4. Wash all tools and equipment immediately with warm water and mild detergent. Allow any unused product to harden in the container and discard according to local regulations.

Features Rust-Oleum EPOXYSHIELD Garage Floor Coating Set

• Professional floor coating
• 2-componenten Epoxy concrete paint system
• Extremely durable
• Satin gloss finish
• Indoor and outdoor use
• Waterbsed
• Odor free after curing
• Consumption: 25 square meters