Pro-Plus Start Cable Set with Isolated Plastic Battery Clamps - TüV/GS-tested

When you start your car, then he makes this short but intensive use of the battery. If the car battery is (almost) empty, it will not be able to start the car. To get it working again you need start cables.

Instructions:

• Make sure that the 2 cars are close together and put both hoods open
• Connect the positive poles (+) of both batteries with the red cable to each other. You do that by confirming the clamp on each pole. The poles are metal points on the battery when other cables are connected.
• Then connect the negative (-) to each other with the black cable
• Start the engine of the car that helps
• Then start the engine of the car with the dead battery
• When the engine is running, remove first the black and then the red cable.

Tips:

• It may be that your car after connecting the battery will not start immediately. Please wait a moment while both batteries are connected and the engine of the car is running. This charges the other battery than on which to start this one. Try again after fifteen minutes
• If you have your car going again, you should not immediately turn off the engine! The battery is now charged minimal and to avoid standing still, it is best to make a ride at least once every two weeks for an hour. When the battery is running, the battery is recharged.

Thumb rule:

• 320A (ca. 2,5 ltr vehicles) - 16 mm cable diameter
• 500A (ca. 3,0 ltr - 4,5 ltr gasoline vehicles) - 25 mm cable diameter
• 700A (ca. 4,0 ltr gasoline / diesel of 3,0 ltr cars and  auto's and trucks - 35 mm cable diameter
• 1000A (Build) - 50 mm cable diameter

Available in various versions:

• Start cable set 16mm² : 3,5 meter length : max 220A
• Start cable set 25mm² : 3,5 meter length : max 350A
• Start cable set 35mm² : 4,5 meter length : max 480A
• Start cable set 50mm² : 5,0 meter length : max 1000A