MIPA 1K Glass Primer Transparent - 1 Litre

Mipa 1K-Glasprimer serves as adhesion promoter for glass surfaces before applying Mipa 2K acrylic and PUR topcoats or Mipa two-coat basecoats. In general, sufficient adhesion strength is ensured on most glass surfaces. On difficult glass surfaces or in case of particularly high requirements on glass coatings it is recommended to use Mipa Glashärter PU 950-25 in in combination with a subsequent Mipa 2K-coating. Please consider the technical data sheet of Mipa PU 950-25. For glass coatings it is generally recommended to test the suitability by an appropriate sample coating.

Mipa 1K-Glasprimer changes the polarity of glass surface and improves thereby the adhesion on glass for subsequent paint coatings.

Use as adhesion promoter, spraying application:

1. Apply Mipa 1K-Glasprimer in thin layers by spray gun. 
2. Allow Mipa 1K-Glasprimer to react for some minutes.
3. Recoating must be done within 24 hours.
4. Recoat with Mipa 2K-acrylic and PUR-topcoats or Mipa two-coat basecoats BC / WBC + Mipa 2K-clearcoats (standard use) or to ensure the best possible adhesion: Recoat with Mipa 2K-acrylic and PUR-topcoats or for two-coat coatings Mipa 2K-topcoats plus Mipa Glashärter PU 950-25 according to technical data sheet Mipa PU 950-25

Use as pretreatment:

1. Apply Mipa 1K-Glasprimer on the glass surface by a sponge or cloth.
2. Allow Mipa 1K-Glasprimer to react for some minutes.
3. Afterwards wipe it again with Mipa 1K-Glasprimer and allow drying. After drying the recoating has to be done within 24 hours.
4. Recoat with Mipa 2K-acrylic and PUR-topcoats or Mipa two-coat basecoats BC / WBC + Mipa 2K-clearcoats (standard use) or to ensure the best possible adhesion: Recoat with Mipa 2K-acrylic and PUR-topcoats or for two-coat coatings Mipa 2K-topcoats plus Mipa Glashärter PU 950-25 according to technical data sheet Mipa PU 950-25

Notes:
Mipa 1K-Glasprimer reacts with moisture. Therefore close immediately the container after material withdrawal. Avoid breathing spray mist.