Evercoat SLICK SAND High Build Polyester Spray Filler

Evercoat Slick Sand primes and levels all at once

Evercoat SLICK SAND is a great high solids, high build polyester based primer surfacer that offers excellent adhesion to metal, galvanized metal, aluminum, wood, fiberglass, SMC, and body filler. Ideally suited for large uneven surfaces. Liquid MEKP activator is included.

Builds in One Coat

Superior Adhesion Its ideal for filling most rough and uneven surfaces in one coat. It has excellent adhesion to fiberglass, SMC, body filler and wood surfaces. Slick Sand is VOC complaint and provides an excellent foundation for any paint system. It is advisable to stir and strain with 190 micron strainer prior to mixing.

Important Features

• Substrates:
• Fiberglass
• SMC
• Rigid Plastics
• Body Filler or Putty
• Epoxy Primer
• Cleaning:
• Surface must be clean and free of dirt, oil, grease and wax
• To solvent clean raw, exposed fiberglass, it is recommended to clean exposed area with acetone.
• Preparation:
• Untreated Steel, Galvanized Steel and Bare Aluminum
• All bare metals must be treated with a high quality self-etch or epoxy primer prior to the application of Slick Sand
• Follow paint company’s recommendations for surface prep and recoat of self-etch or epoxy primer
• Pre-Painted Surfaces
• Sand repair area and featheredge using 180 grit, 220 grit and finish with 320 grit sandpaper on a random orbital sander
• Final clean with a quality wax and grease remover to remove sanding residue prior to applying Slick Sand
• Body Filler or Putty
• Finish sanding body filler or putty with 180-220 grit sandpaper
• Featheredge with 320 grit sandpaper
• Blow off the surface with an air blow gun
• Mixing:
• Shake and stir thoroughly before mixing
• Add one tube (30 gram) liquid hardener to one quart of Slick Sand or 2% by weight and mix thoroughly
• Pot Life is 45 minutes at 75°F (24°C)
• Do not leave product in the spray gun for longer than 30 minutes
• Application:
• Use a primer gun with a 2.0 or larger fluid nozzle/air cap (Spray at paint gun manufacturer’s recommended air pressure)
• Apply 2-3 medium wet coats allowing 10-15 minutes flash
• Finishing:
• Slick Sand will be ready to sand in about 2 hours depending on film build
• Applying over self-etch primer could add 4-6 hours to the dry time
• Once dry, sand Slick Sand with 400-600 grit sandpaper prior to next step 

Technical Specifications:

• Color: Grey Liquid
• Physical state Liquid
• Dry-Film-Thickness (DFT) 4.0 – 6.0 mils per coat
• Solids by volume 57%-62%
• Solids by weight 71%-74%
• Viscosity (Ready to Spray) 30-35 seconds #3
• Coverage at 1 mil 100% Transfer 1200 sq. ft. per U.S. gallon